Multi-Coin Vise
Thread on the Engraving forum about the Coin Holder:
https://engravingforum.com/showthread.php?t=10942

Multi-Coin Vise
Holds Eight Coins with Two Sets of Reversible Jaws Nickel, Quarter, Cent, Dime, Half Dollar Silver Eagle, Morgan Dollar, Native American Clamp block on bottom for mounting in a larger engraving vise.

The Mulit-Coin vise holds some 61 different coins.  Made with US denominations in mind, those measurements happen to accommodate a wide variety of coins from many countries.
Click here for the list of 61 coins.

Multi-Coin Vise
$249

Lindsay Coin holder
For use in engraving vises or lathe chucks
This is made from steel and could rust, so wipe your finger prints off after use to help prevent.


 

Used in a vise

In a thee jaw chuck:  Line the 3 dimples up on holder with jaws. Lip on coin holder aids in clamping so face is concentric.

In a six jaw chuck:  Line 3 dimples up on holder with 3 of the jaws. Lip on coin holder aids in clamping so face is concentric.

For 38mm dia. coins.
Minimum opening requirement of chuck or a vise:
1-5/8"
$78

Hobo Nickel Holder  
For hobo nickel carving or practice engraving on a nickel. 
Made from stainless steel
 

View a hobo nickel holder engraved by Paolo Curcio in 2011. Visit this thread on the forum.

Basic Coin Carving Set w/three stones

-Set of Paolo "MRTHE" Curcio, carving templates (Detail link about these templates)
-Universal point template
-Sharpening metal fixture for templates
-3 diamond bench stones: 260, 1200, and 2000 grits
-3 pack HSS graver blanks
-Stainless adjustable manual palm push graver

Basic Coin Carving Set, w/two stones  (Same as above but with two diamond bench stones, 260 grit and 1200 grit)

Basic Coin Carving set w/two stones (with two diamond bench stones, 260 grit and 1200 grit)
$273